P34C3 — B Camshaft Position Actuator Position Sensor A Circuit High Bank 2
Cam actuator B position sensor on bank 2 signal voltage above expected range. The camshaft position sensor identifies which cylinder is on the compression stroke — without it the ECM cannot run sequential injection or coil-on-plug ignition correctly.
General code reference. Confirm the definition and diagnostic procedure for your vehicle's year, model and engine. A stored code alone does not identify a failed part.
Affected components
- Cam actuator b pos sensor b2
- Sensor wiring
Possible causes to check
These are possible checks, not a ranked diagnosis. Follow the vehicle manufacturer's test procedure before replacing parts.
- Signal wire open
- Connector pins corroded - high contact resistance
- Supply wire pinched against B+ source
Possible symptoms
- Check engine light on
- Power loss especially in mid-rpm range
- Possible rough idle or stalling
- Increased fuel consumption
Diagnostic notes
- The malfunction indicator lamp may illuminate
- This code can affect emissions
Related codes
Sources
Check each reference's vehicle and model-year scope. General background links do not establish which fault is most likely on your vehicle.
Diagnostic information is provided for reference only. Confirm the code with a compatible scan tool and follow the vehicle manufacturer's service procedures before replacing components.