P2C19 — B Camshaft Profile Actuator Position Sensor B Circuit High Bank 1
The position sensor B of camshaft profile actuator on the exhaust side of bank 1 reports a circuit high condition. Cam profile selection feedback cannot be measured reliably.
General code reference. Confirm the definition and diagnostic procedure for your vehicle's year, model and engine. A stored code alone does not identify a failed part.
Affected components
- B camshaft profile actuator pos sensor b b1
- Wiring harness
- Ecm
Possible causes to check
These are possible checks, not a ranked diagnosis. Follow the vehicle manufacturer's test procedure before replacing parts.
- Signal wire shorted to B+
- Open position sensor
- Connector pins corroded - high contact resistance
Possible symptoms
- Check engine light on
- Power loss especially in mid-rpm range
- Possible rough idle or stalling
- Increased fuel consumption
Diagnostic notes
- The malfunction indicator lamp may illuminate
- This code can affect emissions
- Reduced-power or limp mode may occur
Related codes
Sources
Check each reference's vehicle and model-year scope. General background links do not establish which fault is most likely on your vehicle.
Diagnostic information is provided for reference only. Confirm the code with a compatible scan tool and follow the vehicle manufacturer's service procedures before replacing components.