P2776 — Upshift Switch Circuit Low
Voltage on the upshift switch line is below the expected window. Wiring faults of this kind typically come from chafing, water ingress at connector seals, or pin push-back — a wiggle test on the harness while the code is active often confirms the location.
General code reference. Confirm the definition and diagnostic procedure for your vehicle's year, model and engine. A stored code alone does not identify a failed part.
Affected components
- Upshift switch
- Wiring harness
Possible causes to check
These are possible checks, not a ranked diagnosis. Follow the vehicle manufacturer's test procedure before replacing parts.
- Switch wire shorted to ground
- Switch stuck in pressed position
- Connector pins corroded - high contact resistance
Possible symptoms
- Check engine or transmission warning light on
- Harsh, delayed, or missing shifts
- Possible limp mode (locked in one gear)
- Slipping or shuddering during gear changes
Diagnostic notes
- The malfunction indicator lamp may illuminate
Sources
Check each reference's vehicle and model-year scope. General background links do not establish which fault is most likely on your vehicle.
Diagnostic information is provided for reference only. Confirm the code with a compatible scan tool and follow the vehicle manufacturer's service procedures before replacing components.