P2312 — Ignition Coil E Primary Control Circuit Low
The primary control circuit of ignition coil E reads a voltage below the expected level — usually a short to ground on the primary driver wire or a low-resistance fault in the coil primary winding. Coil E cannot build a normal charge, so the cylinder it fires misfires, especially under load. Causes: short to ground in the primary wiring, an internal coil primary fault, or a faulty ECU/igniter driver.
General code reference. Confirm the definition and diagnostic procedure for your vehicle's year, model and engine. A stored code alone does not identify a failed part.
Affected components
- Ignition coil e
- Ignition coil wiring e
- Ignition module
Possible causes to check
These are possible checks, not a ranked diagnosis. Follow the vehicle manufacturer's test procedure before replacing parts.
- Primary winding shorted to ground or harness chafed
- Coil E internal driver fault
- Connector oxidised or loose at coil E
Diagnostic notes
- The malfunction indicator lamp may illuminate
- This code can affect emissions
Related codes
Sources
Check each reference's vehicle and model-year scope. General background links do not establish which fault is most likely on your vehicle.
Diagnostic information is provided for reference only. Confirm the code with a compatible scan tool and follow the vehicle manufacturer's service procedures before replacing components.